 |
|
|
|
|
|
|
 |
|
|
|
Manufacturer
|
|---|
| GE Silicones |
| Acquired by Momentive. See products by manufacturer: Momentive |
| 9930 Kincey Avenue |
| Huntersville |
| NC |
| 28078 |
| 304-746-1654 |
| 877-943-7325 |
| 2011-04-28 |
| Products by this manufacturer |
|
|
|
|
| The following information (Health Effects, Handling/Disposal, and Ingredients) is taken from the product label and/or the Material Safety Data Sheet (MSDS) prepared by the manufacturer. The National Library of Medicine does not test products nor does it evaluate information from the product label or the MSDS. (What is an MSDS?)
|
|
|
|
|
Health Effects
|
|
|---|
| WARNING! UNCURED PRODUCT CONTACT IRRITTES EYES. Eye protection recommended. In case of contact with eyes, immediately flush with water for 15 minutes. If irritation persists, get medical attention. Remove contact lenses before using sealant. Do not handle lenses until all solvent has been cleaned from fingertips, nails and cuticles. Residual sealant may remain on fingers for several days and transfer to lenses during application and curing. Use only in a well ventilated area. Uncured product contact will irritate lips, gums and tongue. Uncured product contact will irritate skin. For cleaning, see directions above (not listed here). Keep out of reach of children. For information call GE Answer Center Service 800-626-2000. (Product No. 612 Clear) Caulk tube. Formula meets Federal Specifications TT-S-001543 A (COM-NBS) |
| TT-S-00230 C (COMS-NBS) |
| ASTM C-920 Type S |
| NS Class 25 use NT |
| 2 |
| N |
| N |
| N |
0 = Minimal; 1 = Slight; 2 = Moderate; 3 = Serious; 4 = Severe;
N = No information provided by manufacturer; * = Chronic Health Hazard |
| 2008-04-16 |
|
|
|
|
|
|
|
|
Handling/Disposal
|
|---|
| Avoid contact with skin and eyes. Caution! Remove contact lenses before using sealant. Do not handle lenses until all sealant has been cleaned from the fingertips, nails and cuticles. Residual sealant may remain on fingers for several days and transfer to lenses and cause severe eye irritation. Product releases acetic acid during application and curing. Use mechanical ventilation to stay below TLV of 10 ppm acetic acid. Product releases ammonia during application and curing. Uncured product contact may irritate eyes and skin. Use in a well ventilated area to prevent irritation by vapors. |
| Dispose of in accordance with applicable federal, state, and local regulations. |
|
|
|
|
|
|
|
|
Ingredients from MSDS/Label
|
|---|
|
|
|
|
|
|
|
|
|
Home
| Brands | Manufacturers
| Ingredients | Health
Effects
|
|
