 |
|
 |
 |
|
 |
 |
 |
 |
 |
Manufacturer
|
Elmers Products, Inc. |
Div. Newell Rubbermaid |
6655 Peachtree Dunwoody Road |
Atlanta |
GA |
30328 |
614-985-2600 |
614-985-2605 |
888-435-6377 |
2017-02-28 |
Products by this manufacturer |
|
|
 |
 |
The following information (Health Effects, Handling/Disposal, and Ingredients) is taken from the product label and/or the (Material) Safety Data Sheet, (M)SDS, prepared by the manufacturer. The National Library of Medicine does not test products nor does it evaluate information from the product label or the (M)SDS. (What is an (M)SDS?)
|
 |
 |
 |
Health Effects
|
|
From MSDS Immediate Hazards INGESTION: No hazards known to Borden. INHALATION: Not expected to be harmful under normal conditions of use. However, if allowed to become airborne, may cause irritation of nose, throat and lungs. SKIN: May cause irritation on prolonged or repeated contact. EYES: May cause irritation on prolonged or repeated contact. |
From MSDS No information on chronic effects given. |
From MSDS None of the components present in this product at concentrations equal to or greater than 0.1% have been listed by NTP, classified by IARC, nor regulated by OSHA as a carcinogen. |
From MSDS INGESTION: If accidentally swallowed, dilute by drinking large quantities of water. Immediately contact poison control center or hospital emergency room for any other additional treatment directions. INHALATION: If inhaled, remove to fresh air. If not breathing, give artificial respiration, preferably mouth-to-mouth. Call a physician. SKIN: If skin bonding occurs, soak in nail polish remover or acetone and carefully peel or roll skin apart (do not pull). EYES: If eye contact occurs, hold eyelid open and rinse thoroughly but gently with only water for 15 minutes and GET MEDICAL ATTENTION. Do not use any solvents to flush the eye and its surroundings. Liquid glue will sting eye temporarily. Solidified glue may irritate eye like a grain of sand and should be treated by an eye doctor. |
2. |
2 |
1 |
0 = Minimal; 1 = Slight; 2 = Moderate; 3 = Serious; 4 = Severe; N = No information provided by manufacturer; * = Chronic Health Hazard |
1999-06-15 |
|
|
 |
 |
 |
 |
 |
Handling/Disposal
|
From MSDS Handle in accordance with good industrial hygiene and safety practices. These practices include avoiding unnecessary exposure and removal of the material from eyes, skin and clothing. Wash thoroughly after handling. INHALATION: Avoid breathing vapor. Use with adequate ventilation. SKIN: Avoid contact with skin and clothing. EYES: Avoid contact with eyes. Storage Store in cool, dry area away from sun and heat. Keep containers tightly closed. Exposure to small amounts of moisture, even moisture in air, causes polymerization and renders the product unusable. Keep away from heat, sparks, flame and other ignition sources. |
From MSDS Dispose of according to local, state/provincial, and federal requirements. Empty container: May contain explosive vapors. DO NOT cut, puncture or weld on or nearby. |
|
|
 |
 |
 |
 |
 |
Ingredients from (M)SDS/Label
|
|
|
 |
 |
|
|
Home
| Brands | Manufacturers
| Ingredients | Health
Effects
 |
|